TEL:0574-63737789   LAN:CN | EN

NEWS

HOME  > NEWS

What is the transmission of the timing belt?

点击数:291    来源:365bet官网   发布日期:2018-04-28

Synchronous belt is a new kind of drive belt that combines the respective advantages of belt drive, chain drive and gear drive.

The transmission of the timing belt is a transmission mode in which the transmission belt and the power are transmitted by the meshing of the belt tooth of the timing belt and the gear teeth of the timing pulley. Therefore, the transmission between the timing belt and the timing pulley has no relative sliding, so as to ensure the accuracy of the transmission ratio when the timing belt is driven.

Synchronous belts usually use steel wire ropes or glass fiber ropes as the tension body of the timing belt, and then use neoprene or polyurethane as the base of the timing belt. Therefore, the light and thin nature of the timing belt allows the timing belt to be used in high speed conveyors and can also be used in multi-axis transmissions.

1523437597779401.jpg

Synchronous belt drive advantages
    1、The timing belt drive has accuracy in the transmission, and the belt body does not slip during operation, so that the timing belt can have a constant transmission ratio.
    2、The speed of the belt in the belt is relatively stable during transmission, and it can have the ability to buffer and damp vibrations, and the emitted noise is also relatively low.
    3、The efficiency of the timing belt in transmission is high and can reach 0.98, so the effect of energy saving is also very obvious.
    4、The speed ratio of the synchronous belt transmission system is relatively large, generally reaching 10, the line speed can reach 50M/S, and can have a range of large power transmission, and can reach several watts or even hundreds of watts.
    5、The timing belt can be used for long-distance transmission, and the center distance between two timing pulleys can reach more than 10M.
    6、The maintenance and service of the synchronous belt transmission system are relatively convenient, and because the transmission system is an intermeshing transmission rather than a frictional transmission, lubrication is not required, and therefore the maintenance cost is also low.
    7、Compared to the transmission of other belts, the preload of the belt drive system is relatively small, so the load on the shaft and the bearing is small.

1523437642279586.jpg

上一篇:The use of flat pulleys.
下一篇:Argon tooth synchronous wheel structure features machine application.
XML 地图 | Sitemap 地图